Sliding snow & ice can become a costly liability. Snow Stop's engineered snow retention system safely controls snow loads, protects people and property, and installs in just three simple steps.
What is snow retention?
On a metal roof, snow and ice can slide off in one sudden, dangerous sheet. Our snow retention system holds that snow on the roof so it melts and drains evenly — protecting gutters, vehicles, landscaping, and anyone standing below.
Our products
From standing seam clamps to heavy-duty snow guards — pick the right fit for your roof type and snow load.



Easy installation
No specialty crew, no roof penetrations on standing seam. Most runs go up fast with basic hand tools.
Clamp onto the standing seam — or fasten the stand to an exposed-fastener panel. No drilling into standing-seam roofs.
Slide the continuous rail through the base across the roof line, spaced to your snow load.
Torque the set screws to spec. POM-tipped, pre-patched stainless screws lock tight without damaging the panel.
Engineered with TitanCore™
TitanCore™ is the high-performance polymer inside every Snow Stop system. Tested, rated, and built for Canadian winters.
Rail rated to 3,000lbs every 18 inches. It flexes under load and springs back to shape.
Validated at −30°C to +70°C, where ordinary plastics turn brittle and crack.
Fully HPT-UVA stabilized, with fade-resistant colours integrated throughout the polymer.
Strong as steel at a fraction of the weight — easier to carry and install.
CANADA'S NATIONAL DISTRIBUTOR
Join our growing network of contractors and distributors bringing trusted snow retention solutions to every corner of Canada.